* Product prices include VAT
New! LH Ultra Thin 20W Driver

New! LH Ultra Thin 20W Driver

New! LH UT40W Driver

Rating:
100 % of 100
£11.50
  • Ultra Thin Driver from LED Hive - ZERO DELAY
  • Zero Interference with Dab radio and Wifi
  • Surge Protection - Hiccup mode - Recovers automatically after condition is removed
  • Thermal Short Circuit Protection
  • Safety Compliant:CE, RoHS & EMC - SELV Approved
Availability: In stock
SKU
LHUT40W
  • Buy 25 for £11.30 each and save 2%
  • Buy 50 for £11.20 each and save 3%
  • Buy 100 for £11.00 each and save 4%

NEW Ultra Thin LED Drivers 


Easy to install simply remove old transformer and replace with these drivers.

If you feel that the LED bulbs you have just purchased are not bright as they should be, or are flickering, then you will require these drivers.

Your current transformers uses a lower frequency hertz and provides AC output which causes LED bulbs to flicker and a reduction in brightness. Running your bulbs with old transformers will surely reduce the life of the LED bulb. If you are going to spend money replacing your MR16 halogens with LED bulbs then please think about also replacing your transformers with these drivers. This will save you money in the long run. 

These LED drivers are suitable for all G4, MR11, MR16/GU5.3 LED bulbs and also most LED strip lights, just make sure the maximum wattage of the strip light does not exceed the output power of the LED driver

   

- Output Voltage (V) 12v DC

- Input Voltage (V) 170 - 240V AC

- 50/60Hz V

- Power output 40w

- Current 3.33A

-  Short circuit and overload protection

- Max Ambient Temp (deg. C) 45 deg. C

- Max Case Temp (deg. C) 80 deg C

- Size: L 160mm x W 57mm x H 20mm

 

Please Note: 

If you have a few LED lamps to dim, then the total wattage will not be enough to load the dimmer. For example, four 5w LED lamps in a small room will only total 20w whilst the minimum load on a 250w dimmer is 25w. This means that the dimmer will simply not work. In these circumstances a low load dimmer rated at 10w – 250w would be required. We recommend Hive Kengo LED Module or Varilight  

Under normal circumstances, so long as the minimum load is exceeded, dimming mains voltage LED lamps is not an issue so long as the minimum load is observed.

 

CE And RoHS Approved:

All Electrical work should be carried out by an qaulified Electrician

More Information
Average Life 50,000
Also Called Transformer | Drivers | Power Supply
Bulb Type MR16 | Strip Light | GU5.3 | M11
Beam Angle Light beam angle in degrees. Defines how wide the light is spread.
Base Indicates the shape or form of the base usually using the width between pins or the diameter of the cap.
Cut Out This is the diameter of the opening required to fit the fitting.
Certification CE - RoHs
Dimmable No
Input Voltage 240v AC - 12v DC
Lumens is the SI derived unit (symbol: <strong>lm</strong> ) of luminous flux, a measure of the total "amount" of visible light emitted by a source.
Replacement for Transformer
Size (Dxl ) L 160mm x W 57mm x H 20mm
Wattage 40W
MSRP 23.50
Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account
We found other products you might like!