LH 12WCBDimm Driver

Rating:
100% of 100
    • Smooth Dimming Technology
    • Very easy to connect
    • 240V to 12V (Transformer)
    • Output Voltage (V) 12v DC
    • Current 1000ma
    • Input Voltage (V) 240V AC 50/60Hz
    • Power output 12W
    • Short circuit and overload protection
    • Max Ambient Temp (deg. C) 40 deg. C
    • Max Case Temp (deg. C) 80 deg C
    • Size: L55mm x W45mm x H 28m
Availability: 449 In stock
SKU
B072DRCTPV
£9.50 £9.50

NEW! LEDHIVE 12W Dimmable LED Drivers Connector Block


Easy to install simply remove old transformer and replace with these drivers.

If you feel that the LED bulbs you have just purchased are not bright as they should be, or are flickering, then you need to install these drivers.

Smooth Dimming Technology. Please ensure you use a suitable LED Dimmer switch which has the correct load.

Your current transformers uses a lower frequency hertz and provides AC output which causes LED bulbs to flicker and a reduction in brightness. Running your bulbs with old transformers will surely reduce the life of the LED bulb. If you are going to spend money replacing your MR16 halogens with LED bulbs then please think about also replacing your transformers with these drivers. This will save you money in the long run. 

These LED drivers are suitable for all G4, MR11, MR16/GU5.3 LED bulbs and also most LED strip lights, just make sure the maximum wattage of the strip light does not exceed the output power of the LED driver

   

- Output Voltage (V) 12v DC

- Input Voltage (V) 240V AC

- 50/60Hz V

- Power output 0.5 - 12w

- Current 1000ma

- Short circuit and overload protection

- Max Ambient Temp (deg. C) 40 deg. C

- Max Case Temp (deg. C) 80 deg C

- Size: L55 x W35 x H28mm

Please Note: 

If you have a few LED lamps to dim, then the total wattage will not be enough to load the dimmer. For example, four 5w LED lamps in a small room will only total 20w whilst the minimum load on a 250w dimmer is 25w. This means that the dimmer will simply not work. In these circumstances a low load dimmer rated at 10w – 250w would be required. We recommend Hive Kengo LED Module or Varilight  

Under normal circumstances, so long as the minimum load is exceeded, dimming mains voltage LED lamps is not an issue so long as the minimum load is observed.


CE And RoHS Approved:

All Electrical work should be carried out by an Electrician

Technical Specification
Average Life 50,000
Also Called Transfomer | Led Driver
Bulb Type MR16 | GU5.3 | G4
Beam Angle Light beam angle in degrees. Defines how wide the light is spread.
Base MR16
Cut Out This is the diameter of the opening required to fit the fitting.
Certification CE | Rohs
Dimmable Yes
Input Voltage 240v AC - 12v DC
Lumens is the SI derived unit (symbol: <strong>lm</strong> ) of luminous flux, a measure of the total "amount" of visible light emitted by a source.
Replacement for Transformer
Size (Dxl ) L55 x W45 x H28mm
Wattage 12W
MSRP 16.50
Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account
We found other products you might like!
LH MR1612W Driver
LH MR1612W Driver
£7.80 £7.80