NEW! Ecoflare GU10 6.5W 240V 620LM

Description

LED Hive has put a lot of effort to overcome the glare problem without losing any light. This ECOFLARE LED Bulb is fitted with SEOUL Super Bright Chips. With each holding 6 multi new 'gen' C.O.B. When the light is released, the slide on lens is able to reflect to the other, and the slide reflects each other, repeating light over and over. Every single slide is carefully calculated and designed. This in return produces a light transmittance rate as much as 92.6% whilst other normal lens reaches only 73% tops. This is by far the brightest and the smartest bulb available in its range and can produce an accurate measured light equivalent to 80W.

These bulbs will install into any GU10 socket with an input voltage of 85 – 265V AC and is designed for any commercial, domestic or retail installation. Only consuming 6.5w of energy compared to 50w halogen, thereby offering significant savings that consumers should not ignore.

Lasting 50,000 hours compared to halogen bulb which only last 1500 – 2000, LED bulbs will pay for themselves within 3 to 6 months of installation. Homeowners and businesses can go many years without the hassle of having to change an LED bulb. Because of the way this bulb is designed there is very little heat generated compared to a halogen bulb. Most of the heat in this bulb is dissipated through its aluminium housing.

Main Features

• 6.5W led bulb producing 620 lumens
• Equivalent to 80W
• 50,000 life span
• Instant light – no warming up
• Shock proof  - unlike filament bulbs
• Environment friendly – LED bulbs contain no Glass or Mercury
• Aluminium Die Cast housing for better heat dissipation

Please Note: 

Non-dimmable LED lamps cannot be dimmed. Should you fit a dimmer to non-dimmable LED’s then damage to the dimmer, lamps or both will occur.

Mains voltage dimmable LED light bulbs can be dimmed using an ordinary resistive dimmer. LED lamps are an attractive proposition as they consume very low wattage's and are very energy efficient. This can cause problems when choosing the correct dimmer.

If you have a few LED lamps to dim, then the total wattage will not be enough to load the dimmer. For example, four 5w LED lamps in a small room will only total 20w whilst the minimum load on a 250w dimmer is 25w. This means that the dimmer will simply not work. In these circumstances a low load dimmer rated at 5 – 50w would be required.

Under normal circumstances, so long as the minimum load is exceeded, dimming mains voltage LED lamps is not an issue so long as the minimum load is observed.